Identifying the Correct 0-10v PortUpdated 6 months ago

Depending on which port you have selected, you'll be using a different port in Apex Fusion™.

If you selected the left RJ45 port on the Apex Base Unit, you'll be using VarSpd1_I1 or VarSpd2_I2 in Apex Fusion.

If you selected the right RJ45 port on the Apex Base Unit, you'll be using VarSpd3_I3 or VarSpd4_I4.

Bring the appropriate VarSpd port down to your Fusion Dashboard.
*If you're unsure which port you're using or things aren't working as expected you can add all 4 ports to your dashboard and test them one by one to be certain.

Power on an EMPTY aF4 and connect the 3.5mm cable to the 0-10v port on the aF4. The link icon on the top right portion of the aF4 UI should illuminate.

1. Choosing one of the VarSpd ports related to the Apex™ Base Station port you selected, enter the following code (the times don't matter, they're just place holders):

Fallback OFF
Set OFF
If Time 18:26 to 18:31 Then ON

2. Go to the Apex Fusion™ Dashboard and switch the port to ON.

3. Wait 10 seconds for the aF4 to activate. If your aF4 activates - congratulations you correctly identified the ports - skip to step 6! If it does not activate, continue to step 4.

4. Copy and paste the code to the other corresponding port on the connector you selected and repeat step 2 and 3. The aF4 SHOULD activate after within 10 seconds, if not continue to step 5.

5. If you've tried both ports without success, you may have mixed up the VarSpd ports. Repeat steps 2/3 on the remaining VarSpd ports until you get a successful activation.

6. Once you've successfully activated your aF4 through your Apex™, move onto the next section for some more detail on programming.