%20(1640%20x%20624%20px).png)
Neptune Apex aF4 coding and hardware setup instructions.
Check out this short video detailing the steps required to get your aF4 connected and controlled by your Neptune Apex. The code below will trigger your aF4 to feed 3 times. Repeat as many times as you'd like or just get a single feed going. APEX COD
Locate the two RJ45 ports on the bottom of the Apex™ Base unit. They're located on the bottom right corner. Ports 1/2 are the left plug and ports 3/4 are the right plug.Insert the inD aquatics 0-10v splitter cable into an available port.Insert the 3.
Depending on which port you have selected, you'll be using a different port in Apex Fusion™.If you selected the left RJ45 port on the Apex Base Unit, you'll be using VarSpd1_I1 or VarSpd2_I2 in Apex Fusion.If you selected the right RJ45 port on the A
Basic Coding:. Fallback OFFSet OFFIf Time 18:26 to 18:31 Then ONFallback OFF (this means that the port will default to OFF if your Apex™ enters a fallback state.)Set OFF (This sets the port to OFF by default)If Time 18:26 to 18:31 Then ON (this sched
Please let us know if there is a better way to do this - but the easiest way we've found is as follows:. Using the VarSpd port you've programmed and identified as the aF4 port - slide it from Auto or Off to the ON position for 10 seconds.The aF4 will